How do you solve error codes on an AEG dishwasher?

In this article, we'll share the solution to the following errors:

• Error code i10 or i11
• Error code i20
• Error code i30
• Error code i41 or i44
• Error code i51 - i59 or 15A - 15F
• Error code iC0 or iC3
• Error code iF1
• Other errors

With an i10 or i11 error code, the dishwasher doesn't get any water. Turn on the water supply and check the water pressure. Put a bucket underneath the water supply and fully turn it open. Within a minute, you should have about 10L water. If that's not the case, call a plumber. Check the supply and drain hose and remove any bends.

Do you see the i20 error code on the display? The dishwasher doesn't drain the water. Check if the drain is clogged and clean it. Then, check the filter systems and clean it. Check the drain hose and remove any bends. Doesn't the error go away? Clean all filters. Check the manual for this.

When you see the i30 error code, the leak protection is enabled. Close the water supply and turn off the dishwasher. Make sure the appliance is installed correctly. In the manual, you'll find all the steps for the proper installation. Place the baskets in the right place and place the dishes as indicated in the manual.

Do you see the i41 or i44 error code? The dishwasher doesn't measure the water level correctly. turn off the appliance and clean the filters. Turn the dishwasher on again afterwards.

With this error code, the dishwasher has a problem with the motor, like a too low or too high voltage. Turn off the appliance and check the filters. Remove any stuck objects like a piece of glass or a skewer. Turn the appliance on again.

With this error, the dishwasher has a technical error. Turn off the dishwasher and turn it back on after a few seconds.

When you see the iF1 error code, the water level in the dishwasher is too high. Turn off the dishwasher. Check the filters and clean them if necessary. Also check the supply and drain hose, and install them as indicated in the manual.

For these errors, we don't recommend to solve the error yourself:

• i61 or i69
• i70
• i80
• i90

A part might be broken. Turn off the dishwasher and contact AEG.

Didn't our tips help? Unplug the connector from the socket or switch the fuse in the fuse box off and on again. After 5 minutes, set everything back to normal. Do you still see the error code? Please contact our customer service. Didn't you buy your dishwasher from Coolblue? Please contact the point of sale or the manufacturer itself. If the warranty period of your dishwasher has expired, you can use our Coolblue repair service.